High Speed Pneumatic Drilling Machine ST 180 Crawler Mounted Drilling Rig
ST 180 Crawler Mounted Drilling Rig introduction
ST 180 is a type of light weight, high efficient, multiple functional drilling hole equipment. Which is equipped with advanced structure, easy to handle,high efficient, durable using etc , widely used for drilling well, farming irrigation well,geothermal air conditionhole and other usage well hole, especially suitable for water intaking in moutainnous area and rock layer.
ST 180 Crawler Mounted Drilling Rig Tech Data
| Drilling Rig Model | ST-180 | Air consumption(m³/min) | 17-31 |
| The Weight(T) | 4.5 | Equipped capacitor(Kw) | 55 |
| Dimensions(mm) | 3800*1550*2350 | Swing speed(rpm) | 45-65 |
| The hole diameter(mm) | 140-254 | Swing torque(N.m) | 3200-4600 |
| Drilling Depth(m) | 180 | Drill pipe diameter(mm) | 76 89 |
| Once-time advance length(m) | 3.3 | Drill pipe length(m) | 1.5 2.0 3.0 |
| Walking speed(Km/h) | 2.5 | Rig lifting force(T) | 10 |
| Climbing angles(Max.) | 30 | sopporting Power | 29m3/min 23BAR AIR COMPRESSOR |
ST 180 Crawler Mounted Drilling Rig Features
1. The engine uses Guangxi Yuchai turbocharged engine;
2. Traveling device: the traveling motor is equipped with reducer, which has long service life;
3. Hydraulic oil pump; Parallel transmission design (patent) separate oil pump, sufficient power supply, reasonable distribution, unique design of hydraulic system, simple maintenance and low cost;
4. Power head unit; The gearbox is integrally cast, and dual motors provide power, with large torque, durability and low maintenance cost;
5. Drilling rig chassis; Professional excavator chassis, durable, large bearing weight, wide chain plate, less damage to hard pavement;
6. Lifting force; Patented composite boom with small volume, long stroke, double oil cylinder lifting and large lifting tonnage;
7. The lifting boom of each drilling rig is equipped with a stopper to protect the oil cylinder and ensure work safety;
ST 180 Crawler Mounted Drilling Rig Operation Attentions
When the drill bit touches the hard soil layer and the drilling speed is slow, it can be pressurized with the pressure rod to speed up. If the drill pipe is skewed, it can be adjusted with the hook on the pressure rod. A mud pit with width of 2m, length of 3M and depth of 1m shall be excavated around 5m away from the drilling machine for slurry mixing when the drilling machine drills into the sand layer. As soon as the thread is disengaged, make it separate immediately. When withdrawing the rod, pay attention to avoid the swing of the mother rod to avoid thread damage. At the same time, the staff shall tighten the steel wire rope. It is used for flushing soil during drilling. Avoid relative movement between external thread and internal thread and wear the thread. After the work of the drilling rig is completed, the rod shall be retracted. When the rod is retracted, pull the lifting wrench to make the drum roll and drive the drill pipe to rise through friction. When the screw head of the mother rod is exposed. When docking the drill pipe, the throttle of the diesel engine shall be small, and the drill pipe shall not swing left and right as far as possible to avoid premature damage of the drill pipe thread. Close the valve under the rotary table and engage the reverse gear to retract the lever.
Product Tags:
|
|
High Speed Pneumatic Crawler Mounted Drill Rig Machine St 180 For Water Well Borehole Drilling Images
|
